Tutorial of P1 HD VRX V1.0.3 - Goggles Internal Power Supply Setup

Note: This methord is only worked on V1.0 III version.

Required Materials:

• 1x P1 HD VRX Nano V1.0.3 (complete set)
• 1x Jumper wire

Procedure:

1. Use the jumper wire to connect the 3 solder pads inside the red box (shown in the image below).

   Caution: Don't allow solder to bridge to adjacent pads.

   

2. After wiring:

   

Precautions when you using the internal power supply:

1. After converting to goggle-side power supply, do not connect an external power source. (Using an external power source after the jumper connection may damage the glasses). (Beta Test version only).
2. Low Voltage Alert must be disabled in the receiver settings. This will not affect normal operation. If left enabled, the device will beep with a low voltage warning.
3. SKYZONE goggles require a corresponding firmware update.

How to Disable Low Voltage Alert:

1. Settings → Device → Low Battery Alert, and toggle the switch to off.

   

How to Update Firmware for SKYZONE Goggles:

1. Connect the goggles to your computer via a USB cable.

   

2. Simultaneously hold the left shuttle wheel button and press the power button to turn on the goggles.

   

   

3. A removable disk drive will appear on your computer.

   

4. Copy the following two files into the removable disk. The update is complete once the file transfer finishes.

   SKY04XPro_A_APP_V4.2.1.bin

   SKY04XPro_C_APP_V4.0.3-1.bin