Antony
- Total activity 101
- Last activity
- Member since
- Following 0 users
- Followed by 6 users
- Votes 2
- Subscriptions 46
Activity overview
Latest activity by Antony-
Antony created an article,
NexRadio DCS Gimbal Installation Guide
NexRadio DCS Gimbal Installation Guide.pdfRemote control firmware:tx16smk3_CN_FLYSKY_GIMBAL_2.12.uf2V16-firmware-2.10.1-092301-CN.bin
-
Antony created an article,
Manual for P1 HD VRX (Standard)
Please kindly check the attached Manual for P1 HD VRX (Standard) .Manual for P1 HD VRX (Standard Version) .pdf
-
Antony created an article,
Manual for Monitor
Please refer to the attached user manual for the Monitor.Manual for Monitor-20260521.pdf
-
Antony created an article,
Tutorial of P1 HD VRX V1.0.3 - Goggles Internal Power Supply Setup
Note: This methord is only worked on V1.0 III version. This tutorial is only applicable to SKYZONE 04X Pro goggles, as well as FatShark ATT‑V6, HDO2 and HDO+ goggles. Required Materials: 1x P1 HD ...
-
Antony created an article,
Firmware for Matrix 1S AIO P1 HD VTX
Note: This FC comes with the onboard P1 Air Unit pre‑flashed with firmware v2.1.1. For compatibility with BETAFPV receivers (P1 VRX Standard, P1 VRX Nano, VR04 HD Goggles, and Monitor), please upgr...
-
Antony created an article,
CLI and Firmware for Pavo20 Pro II 4S (Cube 2-4S 30A FC)
20260812 Firmware Version: BETAFPVG473 V3 Base Firmware: Betaflight 2025.12.5 Supported Gyroscope: ICM42688 / ICM42605 / ICM42622 / LSM6DSK320X Modifications: Updated the firmware version to 202...
-
Antony created an article,
Manual for P1 HD VRX (Nano)
Please kindly check the attached Manual for P1 HD VRX (Nano).Manual for P1 HD VRX (Nano)-20260722.pdf
-
Antony created an article,
Firmware for P1 HD VRX (Standard)
20260605Notes: P1 firmware V2 is incompatible with the V1 series. Interconnection and mutual pairing are not supported. Both the VRX receiver module and VRX Nano receiver module use the P1_GND_VRX ...
-
Antony created an article,
Firmware for P1 HD VRX (Nano)
20260605Notes: P1 firmware V2 is incompatible with the V1 series. Interconnection and mutual pairing are not supported. Both the VRX receiver module and VRX Nano receiver module use the P1_GND_VRX ...
-
Antony created an article,
Firmware for Matrix 1S Brushed Flight Controller
Firmware for Matrix 1S Brushed Flight Controller (5IN1)20260306Update highlights:1. Added support for the BMI270 gyroscope (This flight controller uses the BETAPPVG473_V3 target, which does not sup...