Tutorial of P1 HD VRX V1.0.3 - Goggles Internal Power Supply Setup

Note: 

1. This methord is only worked on V1.0 III version.
2. This tutorial applies only to SKYZONE goggles: SKY04O PRO, SKY04X PRO, SKY04O, SKY04L V2, SKY04X V2, and FatShark goggles: ATTV6, HDO2, HDO+, HDO, HD3.

Required Materials:

• 1x P1 HD VRX Nano V1.0.3 (complete set)
• 1x Jumper wire

Procedure:

1. Use the jumper wire to connect the 3 solder pads inside the red box (shown in the image below).

   Caution: Don't allow solder to bridge to adjacent pads.

   

2. After wiring:

   

Precautions when you using the internal power supply:

1. After converting to goggle-side power supply, do not connect an external power source. (Using an external power source after the jumper connection may damage the glasses). (Beta Test version only).
2. Low Voltage Alert must be disabled in the receiver settings. This will not affect normal operation. If left enabled, the device will beep with a low voltage warning.
3. SKYZONE goggles require a corresponding firmware update.

How to Disable Low Voltage Alert:

1. Settings → Device → Low Battery Alert, and toggle the switch to off.

   

Goggle Built-in Power Supply Modification Tutorial

SKYZONE：Tutorial for P1 HD VRX Nano: Internal Power Supply Mod on SKYZONE Goggles 

Fat Shark：Tutorial for P1 HD VRX Nano: Internal Power Supply Mod on Fat Shark Goggles