Remove the camera module
1. Unscrew the 4 screws fixing the bottom cover at the bottom of the drone and remove the bottom cover；
2.Disconnect the cable between the VTX module and the flight controller, then unscrew the 3 screws fixing the camera top cover and remove the top cover；
3.Unscrew the screws on both sides of the camera canopy and remove the camera module.
Install the camera module
First: Assembling the lens mount：
Note：
1.The lens needs to be facing down vertically to the ground, and the buckle of the camera mount should be facing down toward the lens;
2.The camera mount needs to be installed parallel to the lens to prevent components from being knocked off during mounting.
Second：The method of Lens mounting：
Assembly effect (front, side, back)
Third: Install the new camera module into the canopy and tighten the screws on
the side of the canopy. In order to obtain the best VTX signal, please ensure
that the transmission antenna is placed vertically.
Fourth: Install the canopy and tighten the screws. Please pay attention to the
placement of the image transmission antenna when installing.
Fifth：Connect the cable between the VTX and the flight control, and then
install the bottom cover. The replacement of the camera module has now been
completed.
Comments
3 comments
With what can I replace the original VTX Module?
Is the C04 Camera+VTX Module for Cetus FC compatable?
Edit: i understand this is for replacement in case of damage
ya nadie responde
will this camera with vtx module be available from you? or maybe you can give some other camera instead, for example c04 + vtx module
Please sign in to leave a comment.