BETAFPV
- Total activity 414
- Last activity
- Member since
- Following 0 users
- Followed by 11 users
- Votes 4
- Subscriptions 265
Articles
Recent activity by BETAFPV-
CLI for VTX
Please see the attachments to download the file you need. Note: There are two versions for M03 VTX which needs to flash corresponding frequency tables;
-
STL File for Micro RF Module
Please see attached STL files for Micro RF Module.
-
CLI for HX115 LR
This CLI can be used for F4 1S 12A PRO ELRS FC which is fit for Betaflight_4.2.X_BETAFPVF411 firmware. The picture and file name were marked as 1. Download 1-BTFL_cli_HX115 LR_CRSF_Analog if y...
-
Manual for F4 12A 1S AIO Brushless FC
This is the manual for F4 12A 1S AIO Brushless FC board. ELRS 2.4G receiver version SPI Frsky receiver version The stock firmware of these 2 board are betaflight_4.2.9_STM32F411.hex The Cli d...
-
How to Bind with External ExpressLRS Receiver
How To Bind (No Binding Phrase) If your receiver and TX module didn't set the binding phrase from the ELRS configurator, the binding steps as shown below： 1. Power on and power off the receiver or...
-
STL File for Pavo30 Series
Please see attached the STL file for Pavo30 series, which included GoPro Lite, GoPro8, GoPro5/6/7 and Insta360 Go 2.
-
Manual for F4 1S AIO Brushless FC (No RX)
This is the manual for F4 1S AIO brushless FC board, NO receiver version. This FC board could support 1-2S power. The stock firmware of this board is Betaflight 4.2.0 BETAFPV411RX. The Cli diff d...
-
Manual for F4 1S AIO Brushless FC (SPI Receiver)
This is the manual for F4 1S AIO brushless FC board, with built-in SPI receiver. The stock firmware of this board is Betaflight 4.2.0 MATEKF411RX. The Cli diff dump is in the attached file.
-
STL File for Insta360 Go 2
-
How to Flash Firmware of Lite FC
This manual is only for Lite FC board with LiteSilver firmware. How to update firmware for Lite Brushed V2 board The MCU chip is STM32F042 for this brushed FC board. So we use the DFU mode to re-fl...