BETAFPV

  • Total activity 414
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 11 users
  • Votes 4
  • Subscriptions 265

Articles

Recent activity by BETAFPV Recent activity Votes
  • Tracking Info Has Not Been Updated

    Please note that once your package leaves our warehouse, we will not have any control over it. You should contact the shipping company for tracking information.   There are two scenarios when your ...

  • CLI and Firmware for Air65 Freestyle

    Please confirm the version of Air65 Freestyle before flashing the firmware (Air FC G4 V1.0)   Basic firmware : BETAFLIGHT 4.5.0 Gyro : ICM42688 VTX default frequency point : 5658MHz Note: It is rec...

  • Manual for Pavo20 Pocket Quadcopter

    Please kindly check and download the attached User Manual for Pavo20 Pocket Quadcopter. 

  • LiteRadio 3

    By flashing the LiteRadio 3 Radio Transmitter with firmware version V2024.11.8 or later, a significant upgrade will be unlocked. It not only provides support for the FPV simulator on Steam but als...

  • CLI for Beta85X V2

    This CLI can be used for F405 AIO 12A V3.0 FC which is fit for Betaflight_4.2.X_BETAFPVF405 FC firmware. The picture and file name were marked as 1.  This CLI can be used for F411 AIO 12A FC whi...

  • F4 2S AIO Brushless FC (SPI Frsky RX) Manual

    How to Bind SPI Frsky Receiver Note: If you are using an EU-LBT firmware radio controller, please take a look at this article.   Step 1 Power on the board, either by connecting the battery or USB p...

  • Troubleshooting - How to Enable UART6

    There are solder pads which marks S5 or S6 on some flight control. S5 stands for UART6_TX and S6 stands for UART6_RX, they are a complete set of UART port, which can be used to connect receiver, VT...

  • CLI for X-Knight 360

    This CLI can be used for F722 AIO 35A FC which is fit for Betaflight_4.2.X_BETAFPVF722 FC firmware. The picture is marked as 1 and file named 1-Analog/ Digital.  This CLI can be used for F411 AI...

  • STL File for C01 Pro Camera Mount

      This STL is for C01 Pro camera Mount, it is perfect for upgrading your Brushed & 1S Brushless Whoop Quad camera. It used on the Beta65X 2S Whoop drone.

  • STL File for Naked GoPro HERO8 Case

      Here are the STL files for the Naked GoPro HERO8 Case, feel free to download it.   Infront   Back