The manual is for Lite brushed FC V1 and the Beta65S Lite drone with this FC. The V1 version is black as show below.
For the Lite Brushed FC V2, please follow this manual.
The Beta65S Lite drone is ready to fly and the Silverware firmware does not require a switch setting as Betaflight does. Just bind to your radio transmitter, select the model you want and enjoy it. This manual is also effective for the BETAFPV Lite FC board.
Bind Radio Transmitter
Plugging in a battery and waiting for about 4 seconds, the drone will enter binding status. It is indicated by the LEDs flash stably and slowly.
TX01 Transmitter
Power on the TX01 radio transmitter. Move the throttle stick up and down quickly. Binding procedure finish. If binding successfully, the LEDs on the drone will be solid.
Jumper T8SG Transmitter
Power on the T8SG transmitter. Main menu -> Model menu -> Model setup. Then select the protocol "Bayang" and enter Re-Init. If binding successfully, the LEDs on the drone will be solid.
MTX-9D Module
Slow & Fast Change
In every mode (acro or level), there are 2-speed choices. One is slow and the other is fast. By default, we use channel 9 on the radio transmitter to switch it.
Gestures
By default, certain stick sequences, which we call gestures, are used to activate some features or issue commands. For example, the gesture Down - Down - Down would be accomplished by moving the pitch stick down 3 times in a short time.
1) Change Mode
- Left - Left - Down: acro mode
- Right - Right - Down : level mode
2) Change PID
First, you should select the value you want to change.
- Up - Down - UpCycle PID term to the next ( P - I - D )
- Up - Down - Down Cycle PID axis to be changed ( Roll/Pitch - Yaw )
Second, you could decrease or increase the selected value.
- Up - Down - Left: Decrease the selected value
- Up - Down - Right: Increase the selected value
Finally, save the changed PID value.
- Down - Down - Down Accelerometer calibration / Save PIDs if changed.
3) Calibrate Accelerometer
- Down - Down - Down Accelerometer calibration / Save PIDs if changed.
Comments
1 comment
Hi, I'm new to fpv's so I started with a used whoop. And I saw that the FC says its "Betafpv lite v1.0" i would just want to know what protocol does it use so that i could know what radio should i get. thanks alot.
Please sign in to leave a comment.