Here is the stock Cli commands of TBS Crossfire receivers version 2S whoop drone Beta65X or Beta75X. Of course, there is a difference in drone name.


Beta75X comes with betaflight_3.5.0_OMNIBUSF4SD. You must update the Betaflight Configuration to 10.4.0 for Betaflight firmware 3.5.0 and above.


Go to the CLI tab in Betaflight GUI and copy all these commands in. Do not forget to hit the Enter key to save these configurations.

name x series
feature -RX_PARALLEL_PWM
feature RX_SERIAL
feature LED_STRIP
feature TRANSPONDER
beacon RX_LOST
beacon RX_SET
map TAER1234
serial 0 64 115200 57600 0 115200
serial 5 2048 115200 57600 0 115200
led 0 0,0::A:0
led 1 1,0::A:0
led 2 2,0::L:0
led 3 3,0::L:0
mode_color 6 0 2
aux 0 0 0 1700 2100 0 0
aux 1 1 1 1300 1700 0 0
aux 2 2 1 1700 2100 0 0
aux 3 28 2 900 1300 0 0
aux 4 35 2 1700 2100 0 0
set mag_hardware = NONE
set baro_hardware = NONE
set rssi_channel = 12
set fpv_mix_degrees = 35
set serialrx_provider = CRSF
set blackbox_device = NONE
set dshot_idle_value = 650
set motor_pwm_protocol = DSHOT600
set current_meter = VIRTUAL
set ibatv_scale = 90
set ibatv_offset = 29
set yaw_motors_reversed = ON
set small_angle = 180
set pid_process_denom = 1
set osd_warn_core_temp = OFF
set osd_vbat_pos = 2433
set osd_rssi_pos = 2369
set osd_tim_2_pos = 2455
set osd_flymode_pos = 2425
set osd_throttle_pos = 2401
set osd_crosshairs_pos = 2253
set osd_mah_drawn_pos = 2392
set osd_craft_name_pos = 2442
set vcd_video_system = NTSC
set dterm_notch_cutoff = 0
set vbat_pid_gain = ON
set anti_gravity_gain = 2000
set iterm_relax = RP
set iterm_limit = 500
set pidsum_limit = 1000
set pidsum_limit_yaw = 1000
set p_pitch = 65
set i_pitch = 80
set d_pitch = 50
set f_pitch = 96
set p_roll = 65
set i_roll = 80
set d_roll = 50
set f_roll = 96
set i_yaw = 75
set f_yaw = 100
save