Here is the stock Cli commands of Flysky version 2S whoop drone Beta65 Pro 2 or Beta75 Pro 2. 


Pro 2 Series 2S whoop drones come with betaflight_matekf411rx_4.0.0 (Development Version). You must update the Betaflight Configuration to 10.4.0 for Betaflight firmware 4.0.0



name Pro series
resource MOTOR 5 NONE
resource SERIAL_TX 11 B03
serial 1 2048 115200 57600 0 115200
aux 0 0 0 1350 2100 0 0
aux 1 1 1 1300 1700 0 0
aux 2 2 1 1700 2100 0 0
aux 3 28 2 900 1300 0 0
aux 4 35 2 1700 2100 0 0
set fpv_mix_degrees = 35
set serialrx_provider = IBUS
set dshot_idle_value = 450
set motor_pwm_protocol = DSHOT600
set current_meter = NONE
set yaw_motors_reversed = ON
set small_angle = 180
set pid_process_denom = 1
set osd_warn_no_gps_rescue = OFF
set osd_warn_core_temp = OFF
set osd_warn_rc_smoothing = OFF
set osd_warn_fail_safe = OFF
set osd_warn_launch_control = OFF
set osd_vbat_pos = 2433
set osd_tim_2_pos = 2455
set osd_flymode_pos = 2423
set osd_throttle_pos = 2401
set osd_crosshairs_pos = 2285
set osd_craft_name_pos = 2441
set osd_warnings_pos = 2378
set vtx_channel = 4
set vtx_freq = 5800
set vcd_video_system = NTSC
save