Here is the stock Cli commands of Futaba version 2S whoop drone Beta65 Pro 2 or Beta75 Pro 2. 


The rx is Built-in Futaba, no firmware under the Betaflight GUI. You need to compile by yourself. Please check the attachment to download the firmware.


name Pro series
serial 1 2048 115200 57600 0 115200
aux 0 0 0 1350 2100 0 0
aux 1 1 1 1300 1700 0 0
aux 2 2 1 1700 2100 0 0
aux 3 28 2 900 1300 0 0
aux 4 35 2 1700 2100 0 0
set fpv_mix_degrees = 35
set rx_spi_protocol = SFHSS
set motor_pwm_protocol = DSHOT600
set vbat_max_cell_voltage = 44
set vbat_min_cell_voltage = 30
set vbat_warning_cell_voltage = 31
set current_meter = NONE
set yaw_motors_reversed = ON
set small_angle = 180
set pid_process_denom = 1
set osd_warn_core_temp = OFF
set osd_vbat_pos = 2433
set osd_rssi_pos = 2369
set osd_tim_2_pos = 2455
set osd_flymode_pos = 2423
set osd_throttle_pos = 2401
set osd_crosshairs_pos = 2285
set osd_craft_name_pos = 2442
set osd_warnings_pos = 2378
set vtx_channel = 4
set vtx_freq = 5800
set vcd_video_system = NTSC
set sfhss_spi_tx_id = 132,185
set sfhss_spi_offset = 86
save